|
|
Post by Mark Stubbs (DeCav) on Sept 25, 2015 5:47:35 GMT -4
Can we get Tracy to take a look at this simulation for approval?
Also, the backoff is called out on the major OD only. I am assuming the backoff dimensions are actually for the pilot OD.
Does the major diameter get backed off?
Thanks.
|
|
mitch
New Member
Posts: 11 
|
Post by mitch on Sept 25, 2015 18:00:30 GMT -4
I apologize Mark, I did not get the opportunity today to talk with Tracy about this job. I will follow up with him on Monday.
|
|
mitch
New Member
Posts: 11
|
Post by mitch on Sept 28, 2015 15:11:09 GMT -4
Tracy looked at this simulation today and all looks pretty good for the most part. The only concern was the gash wheel dubbing the margin on the heel side of the flute. Perhaps a different angled gash wheel would keep this from happening...?
You are correct, the back off specs are for the pilot diameter and the major diameter does not have a back off operation.
|
|
|
|
Post by Mark Stubbs (DeCav) on Sept 29, 2015 4:51:02 GMT -4
The only concern was the gash wheel dubbing the margin on the heel side of the flute. Perhaps a different angled gash wheel would keep this from happening...? It sounds like you are describing the operation programmed to grind off the tit left on the 2nd margine after grinding the step...  Can you confirm that and advise me on how to proceed? |
|
